CO2 Equipment

High Pressure Replacement Gauge RH

Right hand thread replacement for high pressure tank gauge. Check your regulator to see if it reguires left hand or right hand thread. Teflon tap recommending for installation.

Regulator Wrench

Wrench designed to remove regulator from CO2 tank.

Low Pressure Replacement Gauge

Replacement for low pressure dispensing gauge. Right hand threaded as opposed to most high pressure tank gauge so the low pressure gauge can’t be attached to high pressure side. Teflon tap recommending for installation.

High Pressure Replacement Gauge LH

Left hand thread replacement for high pressure tank gauge. Check your regulator to see if it reguires left hand or right hand thread. Teflon tap recommending for installation

CO2 distributor 2 Way with 5/16 Barb Shutoff

2 Way CO2 Gas Manifold This 2 way aluminum gas manifold allows you to attach up to 2 kegs to a CO2 regulator. It comes with 5/16” inlet and outlet barbed fittings and the shut off valves are equipped with check valves to protect your regulator...

Shutoff Valve 3/8" x 3/8"

3/8” barbed fitting on both ends. Use as a shutoff when splitting gas lines with a tee fitting. This fitting contains no check so use in conjunction with a gas distributor or regulator that has check valves. 5/16 air line hose with clamps required.

3 Way CO2 Distributor with 5/16 Barb Shutoff

3 Way CO2 Gas Manifold This Aluminum 3 way gas manifold allows you to attach up to 3 kegs to a CO2 regulator. It comes with 5/16” inlet and outlet barbed fittings and the shut off valves are equipped with check valves to protect your regulator...

CO2 Distributor 4 Way with 5/16 Barb Shutoff

4 Way Gas Manifold  This aluminum four way gas manifold allows you to attach up to 4 kegs to one CO2 regulator. It comes with 5/16” inlet and outlet barbed fittings with shut off valves. Shut off valves are equipped with check valves to...

Tee, 3/8" Barb (all)

Stainless steel tee with 3/8” barbed fitting on all sides. Use to split gas line in order to run two kegs from on line. Use gas shutoffs between spit lines if individual shutoffs are desired. 5/16 air line hose with clamps required

CO-2-GO

The CO-2-Go allows you to attach a CO2 regulator to a CO2 paintball cylinder.